Supercycle Bike Fender/Mudguard For Most Bikes, 58 - 86mm

@@@. Hh

This is a trash product

Overall, this fender may seem narrow for a mountain bike, but it works perfectly. The manual is somewhat misleading, so follow these steps to adjust the installation order and method. First, the front fender installation is simple. Note that you should install it "from back to front" to avoid alignment issues caused by the curved bracket. Remember to install the locating pin at the highest position (you can place a support between the fender and the tire during installation). Second, the rear fender installation involves the following steps: 1. Determine the thickness of the steel tube under the seat and replace it with a matching plastic clip. 2. Install the locating pin in reverse. Although the clip on the locating pin helps secure it to the bracket, it also limits the maximum position where the pin can be installed. Therefore, prioritize functionality over convenience. 3. Place the fender on the tire from back to front, attaching the plastic clip at the front of the fender to the steel tube under the seat. 4. Use two semi-circular plastic spacers to install the locating pin onto the steel tube. Remember to install the locating pin at the highest position (you can place a support between the fender and the tire during installation).

Instructions déficientes. Celui pour l’avant n’est pas adapté à mon vélo : il est trop long et on l’accroche en pédalant dès qu’on tourne le guidon un peu.

C’est écrit que c’est un garde boue universel, pourtant ça ne fonctionne pas avec mon vélo qui a des roues 700x38. Je voulais les retourner car le produit est en parfaite condition, mais les retours ne sont pas acceptés car il est déballé. Le seul emballage consiste à un morceau de carton  accroché au garde boue. Je ne recommande pas du tout car ce n’est pas un fit universel.