Fiskars Telescopic Tree Pruner, 12-ft

Warranty is currently working on claims submitted 6/7/25. If your claim was submitted after this date, it hasn't been reviewed yet. This is due to an error that occurred during a recent software transition that caused a backlog.

To install the replacement head on your Fiskars Pruning Stik Extendable Tree Pruner (8–12'), follow these steps: 🔧 What You’ll Need: A Phillips screwdriver or hex wrench (depending on your model) Your replacement head kit 🛠 Installation Steps: Retract the pole fully to make it easier to handle. Remove the old head: Locate the screws or bolts securing the head to the pole. Unscrew them carefully and detach the entire head, including the blade housing and rope/cable mechanism (if applicable). Align the new head with the pole: Position the new head in the same orientation as the old one. Ensure the drive cable or internal linkage (if your model has it) lines up properly inside the pole. Secure the new head: Insert the screws/bolts included with the replacement kit and tighten them securely—but don’t overtighten. Test the cutting action: Pull the orange handle or rope to make sure the blade moves smoothly. Make any tension adjustments if needed. If your pruner has an internal rope or cable mechanism (as many older Pruning Stik models do), it may take a bit of patience to align and tension properly.