Premier Floor Finishing Foam Stain Applicator

The good: while it says that it is for water-based finishes, it worked well for putting some Thompsons (oil-based) stuff on my deck. The bad: I didn't check how tightly the pad was held down when I started. Part way through, the pad comes out of the holder. It was neither easy nor neat to get the sloppy wet pad back between the clamp pieces. I guess at the factory the person gave it a cursory tightening, but a couple more turns would have been good. The ugly: the wing nuts to tighten the pad in place are threaded onto screws. These are flat head screws which have nothing but a bit of friction against the wooden block to keep from turning. So while I am trying to reseat the pad, I need - one hand to tighten, - one hand to hold everything, and - another hand to hold the end of the screw to keep the screw from spinning while the wing nut is turned. Like most people, I don't have three hands. They need to lose the flat heat screws (which are in a countersuck recess) and put in a screw with a hex (bolt) head, which will more likely grip the wood as the wing nut is tightened.

As advertised. The lockers are great!

Very smooth application, works well, exactly what I was looking for

C'est un des meilleurs produits pour appliquer du vernis sans trace de rouleaux ou pinceau...et laisse juste la bonne épaisseur de vernis...

If your refinishing your hardwood floors, this applies evenly and quickly