Mastercraft 12V Lithium-Ion Multi-Crafter Set

A: The battery seems to last 15 minutes at full power, then dies. It takes 30 minutes to recharge. It works fine for the DIY person. For longer use I'd get a 2nd battery. I've used it for 1 week. I've cut door trim to install a floating floor and the ends of metal wire shelving. I've recharged it about 6 times. They also have a corded version for less $. I prefer the cordless as the cord is a hassle. I bought mine on sale for $60. So far so good.

A: It is pretty light, couple of pounds

A: Contact Customer service as your battery is probably dead.

A: is available but expensive, $30+ each. you can buy the 12v drill/driver when it on sell for $60. it comes with two batteries. and total three can share each other.

A: Would not recommend it for any jobs that require more than a quick cut. The battery life is very very limited on this tool.

A: They have a metal blade, but for rebar I think your better off using a grinder. It cuts metal okay, but I think it would take too long for 1/2" rebar. The corded version might give you more power though.

A: The green light should be flashing during charging. This unit has a 3 year exchange warranty against manufacturing defects. To return it for warranty exchange, bring it to any Canadian Tire store within the warranty period, with your receipt. Warranty exchanges without the original receipt will be offered at the Canadian Tire store’s discretion.

A: We just need more info: Does the battery work in other tools? Does the tool work with other batteries?

A: Oui, c'est disponible. Batterie: 54-1259

A: Check that the application tools are correctly attached. Use only the original Mastercraft® accessories and the other approved accessories (Fein® and Rockwell Sonicrafter® accessories) without adaptor. Incorrect or insecurely fastened application tools can come loose during operation and cause a hazard. 1. Remove the battery pack from the Multi-Crafter. 2. Loosen the flange bolt with the hex key provided (fig 5). 3. Ensure that the inner threads and the drive shaft are clean. 4. Align the grooves on the application tool with the four raised ribs on the drive shaft; put the application tool onto the drive shaft. 5. With your gloved hand holding the blade, put on the flange bolt and tighten it with the hex key. The flange is used as an adaptor to permit DREMEL® brand oscillating tool accessories to be mounted on the Multi-Crafter. 1. Remove the battery pack from the Multi-Crafter. 2. Loosen the flange bolt with the hex key supplied, and remove the flange and bolt. 3. Put the selected snap-fit accessory onto the outer flange, making sure that the accessory engages all 12 pins in the outer flange and the accessory is flush against the outer flange, and then put the accessory/outer flange assembly onto the inner flange. 4. Align the grooves on the inner flange with the four raised ribs on the drive shaft; put the inner flange onto the drive shaft. Make sure that the line on the side of the inner flange aligns with the line on the side of the drive shaft (fig 9). 5. With your gloved hand holding the accessory, attach and tighten the clamping bolt with the hex key.