NOCO Genius
NOCO Genius GEN Mini 2 On-board Battery Charger
#011-1938-8
$159.99
Unfortunately, this product is discontinued in your selected store and nearby stores.
You may be interested in these similar products shown below.Similar Items
Quebec residents: For information on maintenance and repair click here.
Similar Items
Product Details
- Features
- Specifications
- Resources
NOCO Genius GEN Mini 2 On-board Battery Charger features 2 independent banks, ideal for charging and maintaing two 12V batteries at the same time
2-bank, 8 amp (4 amps/bank), 12-volt onboard battery charger/maintainer
Simply plug in your extension cord to charge and maintain your batteries right in your vehicle
Waterproof and vibration resistant, ideal for use on boats, RVs, cars, trucks, tractors and more
Charges batteries sizes from 20-120Ah and maintains all battery sizes
8-step smart processor interactively diagnoses, recovers, charges and maintains conventional wet, gel, maintenance-free and AGM battery chemistries
Safe to leave connected indefinitely, will not overcharge
Ignition protected design allows installation in engine bays and near batteries
Variable input compensation allows the battery to achieve 100% full charge even with varying A/C input voltages (i.e. use of extension cord)
Includes safety features such as reverse polarity, short circuit, open circuit, spark proof, overheat, overcurrent and overcharge protection
6’ AC cord, 6.3’ output cords
Dimensions: 7.9” L x 5.5” W x 2.2” H; Weight: 5.8 lbs
| Part Number | GENM2 |
|---|---|
| Accessories List | Instruction Manual |
| Advanced Features | Water Resistant, Over-Charge Protection, Over-Current Protection, Portable, Spark-Proof, Reverse Polarity, Overheat Protection |
| Assembled Height (cm) | 2.20 cm |
| Assembled Height (ft) | 0.07 ft |
| Assembled Height (in) | 0.87 in |
| Assembled Length (cm) | 7.90 cm |
| Assembled Length (ft) | 0.26 ft |
| Assembled Length (in) | 3.11 in |
| Assembled Weight (kg) | 5.80 kg |
| Assembled Weight (lb) | 12.79 lb |
|---|---|
| Assembled Width (cm) | 5.50 cm |
| Assembled Width (in) | 2.17 in |
| Assembled Width (mm) | 55.00 mm |
| Battery Voltage Compatibility | 12V |
| Certifications | UL1236 |
| Charge Control | Multi-Stage |
| Charge Time (Hr) | 0 h |
| Charging Rate Modes | Auto |
| Cord Length (cm) | 72.00 cm |
| Cord Length (ft) | 2.36 ft |
| Cord Length (in) | 28.35 in |
| Crank Assist Amperage (a) | 0 A |
| Display Type | No Display |
| Input Voltage (V) | 70 V |
| Maximum Temperature (°C) | 0.00 °C |
| Maximum Temperature (°F) | 32.00 °F |
| Minimum Temperature (°C) | 0.00 °C |
| Minimum Temperature (°F) | 32.00 °F |
| Output Amperage (amps) | 8 A |
| Primary Colour | Black |
| Primary Material | Plastic |
| Vehicle Type Compatibility | ATV, Automobile, Boat, Light Truck, Motorcycle, SUV, Tractor, Truck, UTV, Van |
Warranty
This product carries a 5 year exchange warranty redeemable at any Canadian Tire store.
Shop Related Products
- Weekly Deals
- Customers Also Viewed
- Top Trending Products
- More From This Brand
Weekly Deals
Review Highlights
List of Pros Highlights
Pros
List of Cons Highlights
Cons
Suitable Cons could not be generated at this time.
Reviews
Filter Reviews
- purchase
- charging
- installation
- satisfaction
- price
- length
- quality
- disappointing
Rating
Locale
1 to 5 of 17 Reviews
1 – 5 of 17 Reviews
Most Recent
5 out of 5 stars.
Works great!
4 years ago
Installed this on a diesel pickup with dual batteries. It charged them from dead and maintains them so they’re ready to go. Glad I bought this.
Yes, I recommend this product.
Helpful?
5 out of 5 stars.
1 seule borne de recharge aurait suffit
4 years ago
Satisfait jusqu'à présent quoiqu' une meilleure explication sur l'emballage aurait éviter l'achat d'un appareil â 2 bornes puisqu'une seule borne de charge etait suffisante pour mon besoin.
Translate with GoogleHelpful?
5 out of 5 stars.
It’s ok
4 years ago
Keeps two marine deep cycle batteries charged and ready for action all winter long
Helpful?
5 out of 5 stars.
Best charger
4 years ago
Great charger, best one ever that i have used for the money i paid
Yes, I recommend this product.
Helpful?
5 out of 5 stars.
Parfait
4 years ago
Parfait quand il est en spécial
!!!!!!!!!!!!!!!!!!!!!!!!!
Translate with GoogleYes, I recommend this product.
Helpful?
1 – 5 of 17 Reviews
Questions
Start typing your question and we'll check if it was already asked and answered.
1 - 10 of 22 Questions
Most helpful answers
Q: I've connected 2 batteries and 1 of them is fully charged (green light is permanently on) but the other battery is not, the red light still on (Red solid charging) It has been charging for the last 3 days. What's happening? Why is that?
6 years ago2 Answers
A: The Charge LED will stay red until the charge cycle is complete and the battery is fully charged to 14.4V +/-0.2V. We would recommend taking a voltage reading of the battery to see where it is at in the charge. If the battery had any built up sulfation from sitting undercharged or being deeply depleted, the bank would have worked to repair that first, increasing the overall charge time and time that the Charge LED will be red. If you are still in need of assistance, please contact NOCO Support directly on the NOCO website.
6 years agoHelpful?
Q: Would this charger be able to charge the MotoMaster Nautilus Group 27 Starting & Deep Cycle Battery?
6 years ago2 Answers
A: Group 27 batteries are typically around 90Ah in capacity, and would be within the charging limits of the GENM2 Mini (120Ah or less). As long as both batteries are within this 120Ah range, the GENM2 Mini can be used to charge and maintain them both. The charger will first fully charge the batteries, and then maintain them as the charger remains plugged into AC power and connected to the batteries.
6 years agoHelpful?
Q: can I leave it plugged into the wall and connected to my 2 batteries all winter long without turning it off? My goal is to keep my batteries top up without un-plugging them during the entire winter.
7 years ago2 Answers
A: As per the vendor: "The GENM2 is designed as a battery maintainer turning off/on automatically to keep batteries fully charged while not overcharging for long periods of time".
7 years agoHelpful?
Q: The manual mention 100 ah maximum but the time table reflect up to 120 a/h. Can I charge a 200a/h battery with this charger or is 120 a/h its limit?
9 years ago2 Answers
A: The manual states that the charger will go into error mode if the charge cycle lasts more than 80 hours.
7 years agoHelpful?
Q: what does 'ignition protected' mean? it looks like there is a bulbose black thing on the red wires. Will the unit work if I have to shorten the red wires and cut these things off? Much thanks....
11 years ago2 Answers
A: sure it will work. they are just fuses. now a person in a white coat who designed this unit who gets payed lots of money decided they are needed. so maybe they should be left alone. they are there so the unit it self is not damaged from electrical spikes in amps. and or any other devices on your aplication. i did a install on one of theses products and had to cut them off while running the wiring. but after i got the wires where they had to go i re soildered them on and heat shrunk my connections.
11 years agoHelpful?
Q: Can this charge lithium 100ah batteries
8 months ago1 Answer
A: No, this older series of NOCO Onboard Chargers is not compatible with lithium batteries. The newer version - model 011-1991 - is compatible with lithium batteries.
8 months agoHelpful?
Q: Can I cut off the eyelets and solder on alligator clamps (using waterproof heat shrink) or will this void the warranty? Obviously leaving the inline fuse where it is. Thanks
6 years ago1 Answer
A: Please contact NOCO (www.no.co) to confirm whether this will void the warranty. While you're at it though, ask them whether the alligator clips (which are removable) on their GC001 will simply bolt onto the GEN Mini 2 eyelets??
6 years agoHelpful?
Q: My boat batteries are in 24v configuration, can I hook this unit up like normal b1 to batt 1 and b2 to batt 2 ?
6 years ago1 Answer
A: Yes. Connect + of bank 1 to the + terminal of battery 1 and same with the -. Connect + of bank 2 to the + terminal of battery 2 and same with the -. The series connection does not need to be disconnected.
Anonymous6 years agoHelpful?
Q: je voudrais branche les deux sur une seule baterie pour faire 8 amp
6 years ago1 Answer
- Translate with Google
A: Oui, vous pouvez connecter les deux banques à une seule batterie.
6 years agoHelpful?
Q: Can the two 4 amp outputs be paralleled to charge one 12 V battery?
7 years ago1 Answer
A: Yes it can be.
7 years agoHelpful?
1 - 10 of 22 Questions
